You may think that this is often a much bigger job than that of putting in a light-weight switch but rest assured! Where there is a will, there is away!
WHAT you'll NEED: 220 Volt Outlet Electrical line tester, Electrical Outlet Boxes, Screwdriver, Wire cutters, Wire strippers, Pliers, and Utility knife. STEP 1: To get started, check the voltage on your outlet. Confirm that it's a 220-volt outlet. It’s vital that the outlet you put matches the plug configuration of your dryer. Next, you would like to seek out the wiring that's to be wont to connect the dryer outlet. Confirm the facility IS Turned Off. You’ll check this line at the breaker. Using the electrical line tester recommended, use it carefully and touch one probe to the black wire of the road and therefore the other to the red wire. If any lights come on, the facility remains on. Confirm that the facility IS OFF. When no lights come on, you'll be able to connect the outlet. STEP 2: If there's the necessity, you'll crop about 3 inches of the outer sheathing on the cable, with the utility knife. Basically, you would like to chop to reveal the four wires to attach to the outlet. The colors of the wires are as follows: black (hot), red (hot), white (neutral), bare/green (ground). Don’t cut too deeply into the sheathing because you would possibly damage the wires inside. Peel the sheathing back and cut it off. STEP 3: Use the wire strippers to strip off about 1 inch of insulation from each of the four wires. If the bottom wire has no insulation, then you'll not get to strip it. STEP 4: Next, you've got to run the wire through the opening within the outlet plate. Line up and mount the plate on the wall using the screws within the kit. All dryer outlets are alleged to have their own electrical plate so you are doing not got to install an Electrical Outlet Box for the wiring. STEP 5: You're almost done! Now that you simply have the outlet mounted to the wall, you would like to connect the black and red wires to the gold- or brass-colored screws (using the included screw and screwdriver). Attach the white (neutral) wire to the silver screw and therefore the green/bare wire to the green screw for the bottom wire. Tighten each screw to a cozy fit. Then, install the duvet plate over the outlet, using an equivalent screw and screwdriver. STEP 6: Turn the facility back on at the most breaker. Using the voltage line tester, you would like to insert one probe into the outlet where the black wire is connected and therefore the other probe where the red wire is connected. The sunshine will now illuminate and show that power is flowing to the outlet. Plug the dryer cord into the outlet. You're done! Now get your clothes within the dryer! For more info :- Electrical Enclosures Visit Us Social Media Update’s :- https://www.youtube.com/user/AlliedMoulded https://www.linkedin.com/company/allied-moulded-products-inc/ https://www.facebook.com/alliedmoulded/ https://www.instagram.com/alliedmouldedproducts/
0 Comments
|